SPECIFICATIONS
USES: Corrugated
co-polymer resin sheets (e.g. Coroplast, Prime Cor-X, etc.) Good
adhesion on some polypropylene, paper, card, etc.
FINISH: Dries to
a high gloss finish.
OPACITY: Good opacity
for most colors.
COVERAGE: Averages
about 2,000 sq. ft. per gallon using 230 mesh monofilament.
DRYING TIME: CRP
Series dries by evaporation. Prints normally air-dry within 30
minutes, or 30 to 60 seconds on a jet dry at 130¾F. Overprints
may require slightly longer due to rewetting of previous color.
Ensure adaquate air circulation when rack drying.
SCREEN FABRIC:
All fabrics are suitable; however, for optimum characteristics
and good outdoor durability, use 200 to 250 monofilament mesh.
Greatest opacity is achieved using 200 mesh monofilament or coarser
fabric. For double sided or work requiring scuff resistance use
280 to 305 mesh monofilament and a sharp squeegee.
SCREEN COATING, FILM, BLOCKOUT:
Direct and indirect photostencils, or water soluble, knife-cut
stencils are suitable.
MODIFIERS: May
be used straight from the can, but 5-15% thinning with CRP-1800
Thinner is recommended for optimum printing characteristics and
leveling. CRP-1370 Extender should be used when conditions require
greater transparency or color brilliance. Use CRP-1700 as a metallic
base.
RETARDER: To improve
screen stability, or under hot shop conditions, use some or all
Slow Thinner CRP-1802.
DIE CUTTING / CREASING:
Can be die cut, test before production.
WASHUP: Use CRP-1840
Washup or biodegradable wash 2500 or 2510 screen wash gel.
ALWAYS TEST PRINT BEFORE PRODUCTION
