Tru-Tone Process Col Non-Phthalate

SPECIFICATIONS:

USES: For use on white cottons, cotton/polyester blends.

FINISH:Cures to a soft-hand finish.

OPACITY: Pure transparent color.

DRYING TIME: Plastisol inks will not air dry and must be heat cured. The printed image will be fully cured when the entire ink deposit reaches 300°F. Curing can be accomplished with the use of a conveyor dryer, flash curing unit, or simple infrared heat source.

SCREEN FABRIC: 305-355T plain weave monofilament polyester screen meshs are recommended for best results. Using coarser meshes will likely result in increased ink deposits and stronger color shades. If you are using retensionable frames, adjust the mesh tension to at least 25 Newtons/cm. Be sure that all screens are at the same tension.

SCREEN COATING, FILM, BLOCKOUT: Use water soluble hand-cut, photo screens and blockouts with this ink or use other suitable products.

MODIFIERS: The PRPE Series Tru-Tone plastisols are supplied ready-for-use direct from the can. Any modification to these inks can have an adverse effect on their performance. If necessary, only reduce with small amounts of PLUE-9000 Reducer/Detackifier. Also, due to the variations among color separations, the PRPE-9080 Clear Base can be used when necessary to reduce color concentrations.

ADHESION: Excellent on 100% Cotton and blends.

WASHUP: T-125 mineral spirits, or biodegradable washes SYS-2500, SYS-2550 or SYS-2510 screen wash gel.