Infinite FX Shimmer Metallics

PRINTING TIPS

Stir inks before printing

Use consistent, high-tensions screen mesh to optimize performance properties

Print in last position or flash after each print if using multiple screens

Print direct to fabric or over a flashed-dried base plate. Use a suitable under base when printing on garments prone to bleed

Tintable with plastisol colorants. See Pigment Loading below for suggested tinting percentages. Adjust the % colorant added based on the strength of the colorants and color saturation desired.

Metallics reflect infrared heat and a forced-air dryer is recommended for curing. If using an electric oven, extend dwell time to achieve proper cure.

Curing is a time and temperature process, a lower over-temperature setting with a slower belt speed while maintaining recommended ink cure temperature is always best to protect fabric, control dye migration, and reduce energy consumption.

15370 and 85570 INFINITE FX SHIMMERS can be cured between 270° F-320° F (132° C-160° C)

Can be mixed with other Infinite FX HD bases or clears.

For cold-peel transfers, use a coated release paper or polyester film. Print using 70 duro squeegee and recommended mesh counts followed by adhesive. Gel at 212° F (100° C) for 60 sec. Apply transfer with head press at 300° F (150° C) for 10-12 sec at medium pressure. For transfers on polyester, back with a low bleed white and/or blocker. Verify process.

RECOMMENDED PARAMETERS

Pigment Loading
Up to 5% with Wilflex PC
Up to 10% with Wilflex EQ
Up to 15% with Wilflex RIO / MX
Up to 10% with Rutland C3 Boosters

Flash Temperature - 220° F (105° C)
Cure Temperature - 270° F (132° C)
Squeegee Durometer - 60/90/60, 60-70
Squeegee Blade - Sharp, Square
Squeegee Angle - 10-15%
Squeegee Speed - Hard flood, Medium
Mesh Count - 86-110 t/in (34-43 t/cm)
Mesh Tension - 25-35 n/cm2
Stencil - 2 over 2, Off Contact: 1/16in, Emulsion over mesh: 15-20%
Substrate Type - cotton, blends, some synthetics
Storage - 65° F to 90° F (18° C to 32° C). Avoid direct sun. Use within one year of receipt
Cleanup - Dispose unused ink responsibly. Standard plastisol cleaners, press wash, or ink degradant

ALWAYS TEST PRINT BEFORE PRODUCTION!